Reflective tapes for standard applications
Part no.
Designation
Article
Description
50106119
REF 4-A-100x100 Reflective tape
Design: Rectangular
Reflective surface: 100 mm x 100 mm
Material: Plastic
Chemical designation of the material: PMMA
Fastening: Self-adhesive
Notes
Observe intended use!
•
This product is not a safety sensor and is not intended as personnel protection.
•
The product may only be put into operation by competent persons.
•
Only use the product in accordance with its intended use.
WARNING! LASER RADIATION – LASER CLASS 2
Never look directly into the beam!
The device satisfies the requirements of IEC 60825-1:2007 (EN 60825-1:2007) safety regulations for a product of
laser class 2
as well as
the U.S. 21 CFR 1040.10 regulations with deviations corresponding to "Laser Notice No. 50" from June 24, 2007.
•
Never look directly into the laser beam or in the direction of reflected laser beams! If you look into the beam path over a longer time
period, there is a risk of injury to the retina.
•
Do not point the laser beam of the device at persons!
•
Interrupt the laser beam using a non-transparent, non-reflective object if the laser beam is accidentally directed towards a person.
•
When mounting and aligning the device, avoid reflections of the laser beam off reflective surfaces!
•
CAUTION! Use of controls or adjustments or performance of procedures other than specified herein may result in hazardous light
exposure.
•
Observe the applicable statutory and local laser protection regulations.
•
The device must not be tampered with and must not be changed in any way.
There are no user-serviceable parts inside the device.
Repairs must only be performed by Leuze electronic GmbH + Co. KG.
NOTE
Affix laser information and warning signs!
Laser information and warning signs are affixed to the device. In addition, self-adhesive laser information and warning signs (stick-on labels)
are supplied in several languages.
•
Affix the laser information sheet to the device in the language appropriate for the place of use. When using the device in the US, use
the stick-on label with the "Complies with 21 CFR 1040.10" note.
•
Affix the laser information and warning signs near the device if no signs are attached to the device (e.g. because the device is too
small) or if the attached laser information and warning signs are concealed due to the installation position.
•
Affix the laser information and warning signs so that they are legible without exposing the reader to the laser radiation of the device or
other optical radiation.
Part no.: 50120754 – BCL 358i OM 100 – Stationary bar code reader
Leuze electronic GmbH + Co. KG, In der Braike 1, D-73277 Owen
[email protected] • www.leuze.com
Phone: +49 7021 573-0, T49 7021 573-199
We reserve the right to make technical changes • eng 2017-10-04
12 / 12