Fast commissioning / operating principle
Leuze electronic
AMS 301
i
10
TNT
35/7-2
4
V
3.2
Connecting the voltage supply
The laser measurement system is connected using M 12 connectors. The voltage supply is
connected via the PWR M 12 connection.
Detailed information can be found in chapter 7.
3.3
Display
Once the laser measurement system is supplied with voltage, the device status as well as
the measured position values can be read on the display. The display automatically switches
to the display of the measurement values.
Use the up/down buttons
to the left of the display to read and change a wide range
of data and parameters.
Depending on connected interface, the network address or IP addresses must be
configured via the display.
Detailed information can be found in chapter 8.
3.4
AMS 301
i
on the RS 485
The transmission parameters are listed above the menu structure or on the fold-out page
at the end of the technical description.
The parameters can be adjusted after activation of parameter enabling.
Detailed information can be found in chapter 9.
