22
INPUT THE TEMPERATURE AND ALTITUDE AT WHICH THE
CLUB SELECTOR SETUP WAS MEASURED.
Once the striking distances have been input, press MODE and
follow these steps:
1) The last saved temperature will be flashing
in the bottom portion of the display . If you
wish to input a temperature other than the
one shown, proceed to step 2 . To save the
shown temperature, press MODE and skip
to step 3 below .
2) Press POWER to begin incrementing through the temperature
settings . The default setting is 75 degrees F (25 degrees
C) . Pressing POWER will increment through a range of 30
degrees to 120 degrees F (0 degrees to 50 degress C) . When
the appropriate temperture is displayed, press MODE to save
your selection and move on to the altitude input .
3) The last saved altitude will be flashing in the bottom portion
of the display . If you wish to input an altitude other than the
one shown, proceed to step 4 . To save the shown altitude
and return to ranging mode, let the unit sit idle for at least
30 seconds until an automatic power-down occurs, or simply
press and hold MODE for at least 2 seconds . To continue
through the Quick Set Menu and manipulate another