Page 5 of 8
Slide both Wings
[H]
onto the
Base
[A]
aligning the holes at
the bottom of the Wing with
holes on the Base.
Thread one (1) Ring Pin
[O]
into the holes located on
each Wing
[H]
securing the
Wings to the Base
[A]
. [Fg.
16 & 17]
NOTE:
The Ring Pin
[O]
MUST
always be threaded
through the hole in the Wing
[H]
from above/inside the
Base
[A]
as shown.
NOTE:
You can use a
straight tool (such as a
Lower Wheel Cradle
[R]
) to
tighten the Ring Pins further if
needed.
A
A
O
H
H
[Fg. 16]
[Fg. 17]
STEP 9:
STEP 9:
Insert two (2) Lower Wheel Cradles
[L]
with Rubber Straps
[M]
facing
in opposite directions into the two (2) Cradle Housing
[J]
installed
below the foam bumpers on each Wing
[H]
. [Fg. 15]
Secure each Lower Wheel Cradle
[L]
with a Retainer Clip
[N]
.
TIP:
The TireBiter carrier and mounted bicycles can be locked to the vehicle using a standard cable lock (not
included) by running a cable through the Ring Pins
[O]
, the tire and the mounted bicycles.
L
L
H
N
N
[Fg. 15]
