www.lesterelectrical.com 22
35827_A
the 3/8-inch self-threading screws into the mounting locations. The screws will thread into a
metal bracket located inside the plastic tray. Tighten until screws are flush and snug against
the enclosure. Do not over tighten. Using longer screws will damage the electronics.
5. Attach the wire connector to the new electronic charge controller as shown in Figure 13B. If
a new BLACK and RED wire harness needs to be installed, connect the RED wire from the
electronic charge controller to the same point as the WHITE positive (+) DC lead on the
diode assembly. The BLACK wire connects to the RED sense lead on the DC output cord
or to the same point as the BLACK negative (-) DC lead on the ammeter assembly. See
Charger Wiring Diagram Section.
Figure 13A
Figure 13B
Guide
Guide
