- 3 -
Warnings
!
All documentation for each major component has been
included with unit. It is strongly recommended that each
document be reviewed before attempting any installation,
operation, or maintenance procedures.
documentation for each major component may also contain
warnings and cautions identified by manufacturer of each
component. These warnings and cautions may be specific for
particular component, and therefore not covered in this general
Installation, Operation, and Maintenance Manual. They should
also be carefully reviewed before attempting installation,
operation, or maintenance procedures.
Connecting Electric Power Source
LESLIE Steam Generators have been wired during assembly.
Connecting electric power supply to unit consists of
connecting correct voltage, phase, and amperage power leads
to terminal strip or circuit breaker. Exact voltage, phase, and -
amperage requirements for unit can be determined from rating
plate affixed to jacket of unit, or from Submittal Sheet and
Wiring Diagrams supplied with unit
Controller – Overview
LESLIE SSCM 2001 control module is a solid state controller
designed to control limit, water feed, alarm, and timed
blowdown functions for LESLIE unfired steam generators.
WARNING!
As with any piece of equipment that utilizes hot/boiler
water or steam and electricity, potential exists for
severe personal injury if proper installation,
operation, and maintenance procedures are not
followed. Listed on following pages are specific
warnings pertaining to LESLIE Electronic Controls.
All warnings should be carefully read and
understood. All precautions contained in warnings
should be carefully followed to reduce chance of
injury.
WARNING!
combination of electricity and water can pose a very
dangerous situation. Assure that all power has been
shut off/disconnected and locked out in an
appropriate manner, before attempting any installation
or maintenance procedures.
WARNING!
Areas of potential danger:
1.
All electric power leads and connections;
2.
All hot/boiler water lines, steam lines, joints,
valves, and relief valves; and
3. All joints at valve, gauges, etc.
WARNING!
Before attempting any installation, operation, or
maintenance procedures pertaining to unit.
1. Assure that electric power supply has been turned
off and locked out in an approved manner;
WARNING!
Hot/boiler water and steam present a situation that can
be very dangerous due to fact it is under pressure and
at very high temperatures. To avoid possible injury or
death, use common sense and follow all accepted and
recommended procedures when performing
installation, operation, and maintenance procedures
.
WARNING!
All installation procedures involving electric power
connection should only be performed by trained,
certified electricians.
WARNING!
Hot/boiler water and steam present a situation that can
be very dangerous because of high temperatures and
pressures. Use common sense and follow all accepted
and recommended procedures when performing
installation, operation, and maintenance procedures to
avoid possible injury or death.
.
WARNING!
combination of electricity and water can pose a very
dangerous situation. Assure that all power has been
shut off/disconnected and locked out in an approved
manner, before attempting any installation or
maintenance procedures.
