65
PARAMETER SETTING MANUAL
VARMECA 20
Variable speed motors and geared motors
COMMISSIONING THE PEGASE VMA 20 PC PARAMETER SOFTWARE
LEROY-SOMER
3532 - 05.2004 / f
en
3.3.3 - Setting the VARMECA parameters
The VARMECA parameters are set from the following screen:
1) First you should enter the VARMECA software version (A or B) and the motor rating.
To be able to export the PC parameters to the VARMECA, both these parameters MUST correspond to those set in
the factory.
If you do not know either of these parameters, you can find them as follows:
- Connect the VARMECA to the PC (section 3.1.3 on connection).
- Switch on the VARMECA.
- Click the "import" key
.
- The PC reads the VARMECA parameters and updates the above settings page and in particular the "software version" and
"motor rating" windows.
2) Modify the settings required for your application.
3) Save these settings in a special file if necessary (parameter backup, etc) (section 3.3.2.5).
4) Transfer the settings from the PC to the VARMECA:
- Connect the VARMECA to the PC (section 3.1.3 on connection).
- Switch on the VARMECA (run command disabled)
- Click the
key.
A red arrow appears at the top right of the screen for a few seconds. When this arrow disappears, parameter loading is complete.
Software version (A or B)
Motor rating
