Assembly
Always make sure the juicer is unplugged
before beginning assembly.
1 Place the
on top of the motor
base Two tabs located on the underside
of the
should rest in two
accompanying slots on top of the motor
base. (The tabs and slots are by
each clamp.)
2. Set the blade/basket on the hub in the
center of the
and press down
it feels snug.
3 Gently rotate the blade/basket to ensure
that it turns freely. If initially it failed to
seat, this should slip it into place Double
check by pressing down and spinning
it again.
Place the clear cover over the iuicebowl
with the large pulp ejection opening
toward the back of the juicer.
5. Place the tops of the clamps on the
respective slots on the cover, leaving the
clamp hinges resting out. Press the bottom
of the clamps in, until they snap snugly
into place.
6. Place the pulp basket under the pulp spout
behind the
