3
LED Indicators
There are LED light indicators located on the front panel of the industrial PoE Injector that
display the power and PoE status. Each LED indicator has a different color and has its own
specific meaning, see below in Table 2.4.
LED
Color
Description
PWR
Green
On
Power input 1 or 2 is active
Off
Power input 1 and 2 is inactive
PoE
Green
On
The port is supplying power to the
powered-device
Off
No powered-device attached or power
supplying fails
Table 2.4: LED Indictors for GINJ-0201-AT-24 Series
Caution:
"PWR" is the abbreviation for "Power".
Cabling
Use the four twisted-pair, category 5e, or the above cabling for RJ-45 port connections. The total
length from the device A through the INJECTOR to the device B must not exceed 100 meters.
Wiring the Power Inputs
Caution:
Please follow the below steps to insert the power wire.
Step 1
Insert the positive and negative wires into the PWR1 (V1+, V1-) and PWR2 (V2+, V2-)
contacts on the terminal block connector as shown below in Figure 2.5.
Figure 2.5: Power Terminal Block
