9
Wiring the Power Inputs
Caution:
Please follow the below steps to insert the power wire.
Step 1
Insert the positive and negative wires into the PWR1 (V1+, V1-) and PWR2 (V2+, V2-)
contacts on the terminal block connector as shown below in Figure 2.8.
Figure 2.8: Power Terminal Block
Step 2
Tighten the wire-clamp screws to prevent the wires from loosening, as shown below in
Figure 2.9.
Figure 2.9: Power Terminal Block
Caution:
Only use copper conductors, 100°C, tighten to 5 in-lbs.
The wire gauge for the terminal block should range between 18~20 AWG.
