25
Related service information
Power management
Note:
Power management modes are not supported for APM operating system.
To reduce power consumption, the computer has three power management
modes: screen blank, sleep (standby), and shut down.
Screen blank state
If the time set on the “Turn off monitor” timer in the operating system expires,
the LCD backlight turns off. You can also turn off the LCD backlight by
pressing
Fn +
F2
.
To end screen blank state and resume normal operation, press any key.
Putting the computer to sleep or shutting it down
When you have finished working with your computer, you can put it to sleep or
shut it down.
Putting your computer to sleep
If you will be away from your computer for only a short time, put the computer to
sleep. When the computer is in sleep mode, you can quickly wake it to resume
use, bypassing the startup process. To put the computer to sleep, do one of the
following:
• Close the display panel.
• Press the power button.
• Open the Charms and then select
Settings
→
Power
→
Sleep
.
Attention:
Wait until the power indicator light starts blinking (indicating that
the computer is in sleep mode) before you move your computer. Moving your
computer while the hard disk is spinning can damage the hard disk, causing
loss of data.
To wake the computer, do one of the following:
• Press any key on the keyboard.
• Press the power button.
Shutting down the computer
If you are not going to use your computer for a long time, shut it down. To shut
down your computer:
• Open the charms bar, then select
Settings
→
Power
→
Shut down.
• Right-click the
Start
button in the lower-left corner and select
Shut down or
sign out
→
Shut down
.
