Lenovo x3250 m6, Installation And Service Manual

Page: 46 / 696

System-event log contains POST and system management interrupt (SMI) events and all events that are
generated by the baseboard management controller that is embedded in the Integrated Management
Module II (IMM2).
Important: If the system-error LED on the front of the server is lit but there are no other error indications,
clear the system-event log. Also, after you complete a repair or correct an error, clear the system-event
log to turn off the system-error LED on the front of the server.
– POST Event Viewer
Select this choice to enter the POST event viewer to view the POST error messages.
– System Event Log
Select this choice to view the system event log.
– Clear System Event Log
Select this choice to clear the system event log.
• User Security
Select this choice to set, change, or clear passwords. For more information, see “Passwords” on page 32.
– Set Power-on Password
Select this choice to set or change a power-on password. For more information, see “Power-on
password” on page 33.
– Clear Power-on Password
Select this choice to clear a power-on password. For more information, see “Power-on password”
on page 33.
– Set Administrator Password
Select this choice to set or change an administrator password. An administrator password is intended
to be used by a system administrator; it limits access to the full Setup Utility menu. If an administrator
password is set, the full Setup Utility menu is available only if you type the administrator password at
the password prompt. For more information, see “Administrator password” on page 33.
– Clear Administrator Password
Select this choice to clear an administrator password. For more information, see “Administrator
password” on page 33.
• Save Settings
Select this choice to save the changes that you have made in Setup Utility.
• Restore Settings
Select this choice to cancel the changes that you have made in Setup Utility and restore the previous
settings.
• Load Default Settings
Select this choice to cancel the changes that you have made in Setup Utility and restore the factory
settings.
• Exit Setup
Select this choice to exit Setup Utility. If you have not saved the changes that you have made in Setup
Utility, you will be asked whether you want to save the changes or exit without saving them.
Passwords
From the User Security menu choice, you can set, change, and delete a power-on password and an
administrator password.
The User Security menu choice is on the full Setup Utility menu only.
32
Lenovo System x3250 M6 Installation and Service Guide