Lenovo ThinkSystem NE2552E, Application Manual

Page: 378 / 574

378
NE2552E Application Guide for ENOS 8.4
What is a Route Map?
A route map is used to control and modify routing information. Route maps define
conditions for redistributing routes from one routing protocol to another or
controlling routing information when injecting it in and out of BGP. For example, a
route map is used to set a preference value for a specific route from a peer router
and another preference value for all other routes learned via the same peer router.
For example, the following commands are used to define a route map:
A route map allows you to match attributes, such as metric, network address, and
AS number. It also allows users to overwrite the local preference metric and to
append the AS number in the AS route. See “BGP Failover Configuration” on
page 384 .
Lenovo ENOS allows you to configure 32 route maps. Each route map can have up
to eight access lists. Each access list consists of a network filter. A network filter
defines an IPv4 address and subnet mask of the network that you want to include
in the filter. Figure 38 illustrates the relationship between route maps, access lists
and network filters.
Figure 38.
Distributing Network Filters in Access Lists and Route Maps
NE2552E(config)# route-map
<map number> (Select a route map)
NE2552E(config-route-map)# ?
(List available commands)
Access Lists
(alist)
Network Filter
(nwf)
Route Maps
(rmap)
1
Route Map 1
8
1
8
1
Route Map 2
8
9
16
1
Route Map 32
8
249
256
-----
---
---
---
---
---
---
---
---
---