Lenovo ThinkSystem NE1032, Installation Manual

Page: 56 / 112

56
NE1032 Installation Guide
Removing Port Transceivers
Statement 3
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
 Do not remove the covers. Removing the covers of the laser product could result
in exposure to hazardous laser radiation. There are no serviceable parts inside
the device.
 Use of controls or adjustments or performance of procedures other than those
specified herein might result in hazardous radiation exposure.
DANGER
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
Appareil À Laser de Classe 1
To remove one of the installed SFP or SFP+ transceiver modules from the switch,
complete the following steps:
1.
Disconnect the port cable from the transceiver.
2.
Pull down the locking lever to release the transceiver.
3.
Gently slide the transceiver out of the switch.
4.
After you remove the transceiver, replace the safety cap.
To replace the transceiver module, see the appropriate section under “Installing
Port Transceivers” on page 51 .
Some laser products contain an embedded Class 3A or Class 3B laser diode.
Note the following.
Laser radiation when open. Do not stare into the beam, do not view directly
with optical instruments, and avoid direct exposure to the beam.