Lenovo ThinkServer TS150, User Manual And Hardware Maintenance Manual

Page: 75 / 148

6. Connect cables to the drive.
2
1
4 5
3
Figure 39. Connecting cables to the drive
Cable
From the system board To the drive
1-to-3 power cable
1
or
2
4-pin power connector
4
Power connector on the drive
Signal cable
3
SATA connector 2
5
Signal connector on the drive
Note: The 1-to-3 power cable provides three SATA power connectors 1 , 2 , and 3 . You can connect
any one of the SATA connectors to the drive.
2
1
3
Storage drive in drive bay 4
Drive bay 4 of your server supports one of the following:
• RDX tape drive
For instructions on how to remove or install the tape drive, see “Tape drive” on page 50.
• Secondary optical drive
For instructions on how to remove or install the optical drive, see “Optical drive” on page 47.
• Storage drive: a 2.5-inch/3.5-inch hard disk drive or 2.5-inch solid-state drive
The storage drive is installed in a Lenovo ThinkServer TS150 3.5" HDD to 5.25" Tray Convertor Kit
(hereinafter called the 5.25-inch convertor kit).
– “Removing a storage drive from drive bay 4” on page 61
– “Installing a storage drive into drive bay 4” on page 63
For information about drive bays and installation rules, see “Internal drives” on page 44.
Removing a storage drive from drive bay 4
To remove a storage drive from drive bay 4, do the following:
1. Prepare your server. See “Preparing your server and removing the server cover” on page 41.
Chapter 5
.
Replacing hardware
61