Lenovo ThinkCentre Edge 71, Hardware Maintenance Manual

Page: 137 / 230

Replacing the system board
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
in the
ThinkCentre User Guide . To obtain a copy of the ThinkCentre User Guide , go to:
http://www.lenovo.com/ThinkCentreUserGuides
This section provides instructions on how to replace the system board.
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and wait three to five
minutes to let the computer cool before opening the computer cover.
To replace the system board, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See “Removing the computer cover” on page 109.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on page 110.
4. Pivot the optical drive bay assembly upward to gain access to the system board. See “Accessing the
system board components and drives” on page 111.
5. Remove all memory modules and PCI cards that are currently installed. See “Installing or replacing a
memory module” on page 115 and “Installing or replacing a PCI card” on page 113.
6. Remove the heat sink and fan assembly from the failing system board. See “Replacing the heat sink and
fan assembly” on page 127.
7. Carefully take note of the location of all cable connections on the system board and disconnect all the
cables. See “Locating parts on the system board” on page 107.
Chapter 9
.
Replacing FRUs (Machine Types: 1578, 1583, and 1652)
133