Lenovo System x3250 M5, Installation And Service Manual

Page: 37 / 740

Chapter 2. Installing optional devices
This chapter provides detailed instructions for installing optional hardware devices in the server.
In addition to the instructions in this chapter for installing optional hardware devices, updating the firmware
and device drivers, and completing the installation, Business Partners must also complete the steps in
“Instructions for Business Partners” on page 23.
Important: To help ensure that the devices that you install work correctly and do not introduce problems,
observe the following precautions.
Step 1. Make sure that the server and the installed firmware levels support the devices that you are
installing. If necessary, update the UEFI and IMM2 firmware and any other firmware that is
stored on the system board. For information about where firmware is stored in the server, see
“Updating the firmware” on page 85. For a list of supported optional devices for the server, see
http://www.lenovo.com/us/en/serverproven/.
Step 2. Use the best practices to apply current firmware and device-driver updates for the
server and optional devices. To download the
Firmware Update Guides document, go to
http://www.ibm.com/support/entry/portal/docdisplay?lndocid=MIGR-5082923. Additional hints
and tips are available from the following website:
• Lenovo support: http://www.lenovo.com/support
• System x configuration tools: http://www.ibm.com/systems/x/hardware/configtools.html
Step 3. Before you install optional hardware devices, make sure that the server is working correctly. Start
the server and make sure that the operating system starts, if an operating system is installed, or
that a 19990305 error code is displayed, indicating that an operating system was not found but
the server is otherwise working correctly. If the server is not working correctly, see “Running DSA
Preboot diagnostic programs” on page 126 for information about how to run diagnostics.
Step 4. Follow the installation procedures in this chapter and use the correct tools. Incorrectly installed
devices can cause system failure because of damaged pins in sockets or connectors, loose
cabling, or loose components.
Instructions for Business Partners
Instructions for Business Partners on verifying the newly installed devices by running the Dynamic System
Analysis (DSA) stress test.
In addition to the instructions in this chapter for installing optional hardware devices, updating firmware and
device drivers, and completing the installation, Business Partners must also complete the following steps:
1. After you have confirmed that the server starts correctly and recognizes the newly installed devices and
that no error LEDs are lit, run the Dynamic System Analysis (DSA) stress test. For information about
using DSA, see “Dynamic System Analysis” on page 124.
2. Shut down and restart the server multiple times to ensure that the server is correctly configured and
functions correctly with the newly installed devices.
3. Save the DSA log as a file and send it to Lenovo. For information about transferring data and logs,
see “Sending DSA data to Lenovo” on page 24.
4. To ship the server, repackage it in the original undamaged packing material and observe Lenovo
procedures for shipping.
Support information for Business Partners is available at http://www.ibm.com/partnerworld.
© Copyright Lenovo 2015 23