Lenovo RackSwitch G8332, Command Reference Manual

Page: 590 / 776

590
G8332 Command Reference for ENOS 8.4
IPsec Manual Policy Configuration
The following table describes the commands used to configure an IPsec manual
policy.
Table 323.
IPsec Manual Policy Options
Command Syntax and Usage
ipsec manual ­ policy
<1 ‐ 10>
Enter IPsec manual policy mode.
Command mode: Global configuration
in ­ ah auth ­ key
<key code (hexadecimal)>
Sets inbound Authentication Header (AH) authenticator key.
Note : For manual policies, when peering with a third ‐ party device, key
lengths are fixed to 20 characters for SHA1.
Command mode: IPsec manual policy
in ­ ah spi
<256 ‐ 4294967295>
Sets the inbound Authentication Header (AH) Security Parameter Index (SPI).
Note : For manual policies, when peering with a third ‐ party device, key
lengths are fixed to 20 characters for SHA1.
Command mode: IPsec manual policy
in ­ esp {auth ­ key|cipher ­ key}
<key code (hexadecimal)>
Sets the inbound Encapsulating Security Payload (ESP) authenticator key or
cipher key.
Note : For manual policies, when peering with a third ‐ party device, key
lengths are fixed to 8 characters for DES and to 24 characters for 3DES and
AES ‐ CBC encryption.
Command mode: IPsec manual policy
in ­ esp spi
<256 ‐ 4294967295>
Sets the inbound Encapsulating Security Payload (ESP) Security Parameter
Index (SPI).
Note : For manual policies, when peering with a third ‐ party device, key
lengths are fixed to 20 characters for SHA1.
Command mode: IPsec manual policy
out ­ ah auth ­ key
<key code (hexadecimal)>
Sets the outbound Authentication Header (AH) authenticator key.
Note : For manual policies, when peering with a third ‐ party device, key
lengths are fixed to 20 characters for SHA1.
Command mode: IPsec manual policy