Lenovo RackSwitch G8332, Command Reference Manual

Page: 546 / 776

546
G8332 Command Reference for ENOS 8.4
OSPFv3 AS-External Range Configuration
The following table describes the OSPFv3 AS ‐ External Range commands.
Table 288.
OSPFv3 AS_External Range Configuration Options
Command Syntax and Usage
summary ­ prefix
<1 ‐ 16>
address
<IPv6 address> <IPv6 prefix length (1 ‐ 128)>
Configures the base IPv6 address and the subnet prefix length for the range.
Command mode : Router OSPF3
summary ­ prefix
<1 ‐ 16>
aggregation ­ effect {allowAll|denyAll|
|advertise|not ­ advertise}
Configures the aggregation effect, as follows:

allowAll
: If the area ID is 0.0.0.0, aggregated Type ‐ 5 LSAs are generated.
Aggregated Type ‐ 7 LSAs are generated in all the attached NSSAs for the
range.

denyAll
: Type ‐ 5 and Type ‐ 7 LSAs are not generated.

advertise
: If the area ID is 0.0.0.0, aggregated Type ‐ 5 LSAs are generated.
For other area IDs, aggregated Type ‐ 7 LSAs are generated in the NSSA area.

not ­ advertise
: If the area ID is 0.0.0.0, Type ‐ 5 LSAs are not generated,
while all NSSA LSAs within the range are cleared and aggregated Type ‐ 7
LSAs are generated for all NSSAs. For other area IDs, aggregated Type ‐ 7
LSAs are not generated in the NSSA area.
Command mode : Router OSPF3
summary ­ prefix
<1 ‐ 16>
area
<area index (0 ‐ 2)>
Configures the area index used by the switch.
Command mode : Router OSPF3
[no] summary ­ prefix
<1 ‐ 16>
translation
When enabled, the P ‐ bit is set in the generated Type ‐ 7 LSA. When disabled, the
P ‐ bit is cleared. The default setting is
disabled
.
Command mode : Router OSPF3
[no] summary ­ prefix
<1 ‐ 16>
enable
Enables or disables the OSPFv3 AS ‐ external range.
Command mode : Router OSPF3
no summary ­ prefix
<1 ‐ 16>
Deletes the OSPFv3 AS ‐ external range.
Command mode : Router OSPF3
show ipv6 ospf summary ­ prefix
<1 ‐ 16>
Displays the current OSPFv3 AS ‐ external range.
Command mode : All