Lenovo RackSwitch G8332, Command Reference Manual

Page: 425 / 776

© Copyright Lenovo 2016 Chapter 4: Configuration Commands
425
ACL Re-Mark Configuration
You can choose to re ‐ mark IP header data for the selected ACL. You can configure
different re ‐ mark values, based on whether packets fall within the ACL Metering
profile, or out of the ACL Metering profile.
Re-Marking In-Profile Configuration
The following table displays Re ‐ Marking In ‐ Profile configuration commands:
Table 199.
ACL Re ‐ Marking Configuration Options
Command Syntax and Usage
default access ­ control list
<1 ‐ 256>
re ­ mark
Sets the ACL re ‐ mark parameters to their default values.
Command mode: Global configuration
show access ­ control list
<1 ‐ 256>
re ­ mark
Displays current re ‐ mark parameters.
Command mode: All
Table 200.
ACL Re ‐ Marking In ‐ Profile Options
Command Syntax and Usage
access ­ control list
<1 ‐ 256>
re ­ mark dot1p
<0 ‐ 7>
Re ‐ marks the 802.1p value. The value is the priority bits information in the
packet structure.
Command mode: Global configuration
no access ­ control list
<1 ‐ 256>
re ­ mark dot1p
Disables the use of 802.1p priority for in ‐ profile traffic.
Command mode: Global configuration
access ­ control list
<1 ‐ 256>
re ­ mark in ­ profile dscp
<0 ‐ 63>
Re ‐ marks the DSCP value for in ‐ profile traffic.
Command mode: Global configuration
no access ­ control list
<1 ‐ 256>
re ­ mark in ­ profile [dscp]
Deletes the re ‐ mark in ‐ profile configuration. The
dscp
option only disables
the use of DSCP for in ‐ profile traffic.
Command mode: Global configuration
[no] access ­ control list
<1 ‐ 256>
re ­ mark use ­ tos ­ precedence
Enables or disables mapping of TOS (Type of Service) priority to 802.1p
priority for in ‐ profile packets. When
enabled
, the TOS value is used to set the
802.1p value.
Command mode: Global configuration