Lenovo RackSwitch G8264CS, Cli Command Reference

Page: 502 / 702

502
G8264CS Command Reference for ENOS 8.4
OSPFv3 Interface Configuration
The following table describes the OSPFv3 Interface commands.
Table 278.
OSPFv3 Interface Configuration Options
Command Syntax and Usage
interface ip
<1 ‐ 128>
Enter Interface IP mode, from Global Configuration mode.
Command mode : Global configuration
ipv6 ospf area
<0 ‐ 2>
Configures the OSPFv3 area index.
Command mode : Interface IP
ipv6 ospf area
<0 ‐ 2>
instance
<0 ‐ 255>
Configures the instance ID for the interface.
Command mode : Interface IP
ipv6 ospf cost
<1 ‐ 65535>
Configures the metric value for sending a packet on the interface.
Command mode : Interface IP
no ipv6 ospf cost
Removes the metric value for sending a packet on the interface.
Command mode: Interface IP
ipv6 ospf dead ­ interval
<1 ‐ 65535>
Configures the time period, in seconds, for which the router waits for
hello
packet from the neighbor before declaring this neighbor down.
Command mode : Interface IP
no ipv6 ospf dead ­ interval
Resets the dead interval for hello packets to its default value.
Command mode: Interface IP
[no] ipv6 ospf enable
Enables or disables OSPFv3 on the interface.
Command mode : Interface IP
ipv6 ospf hello ­ interval
<1 ‐ 65535>
Configures the indicated interval, in seconds, between the
hello
packets, that
the router sends on the interface.
Command mode : Interface IP
no ipv6 ospf hello ­ interval
Resets the hello interval for hello packets to its default value.
Command mode: Interface IP