Lenovo RackSwitch G8264, Command Reference Manual

Page: 523 / 794

© Copyright Lenovo 2017 Chapter 4: Configuration Commands
523
Routing Map Configuration
Routing maps control and modify routing information.
Note:
The map number (1 ‐ 255) represents the routing map you wish to configure.
Table 273.
Routing Map Configuration Options
Command Syntax and Usage
route ­ map
<1 ‐ 255>
Enter route map configuration mode.
Command mode: Global configuration
access ­ list
<1 ‐ 32>
Configures the Access List. For more information, see page 526 .
Command mode: Route map
as ­ path ­ list
<1 ‐ 8>
Configures the Autonomous System (AS) Filter. For more information, see
page 529 .
Command mode: Route map
as ­ path ­ preference
<1 ‐ 65535>
Sets the AS path preference of the matched route. You can configure up to 32
path preferences.
Command mode: Route map
no as ­ path ­ preference
Removes the AS path preference of the current route map.
Command mode: Route map
[no] enable
Enables or disables the route map.
Command mode: Route map
local ­ preference
<0 ‐ 4294967294>
Sets the local preference of the matched route, which affects both inbound and
outbound directions. The path with the higher preference is preferred.
Command mode: Route map
no local ­ preference
Removes the local preference of the current route map.
Command mode: Route map
metric
<1 ‐ 4294967294>
Sets the metric of the matched route.
Command mode: Route map