Lenovo NeXtScale nx360 M4, Installation And Service Manual

Page: 157 / 738

1
2
3.5-inch Hard disk
drive cage
3.5-inch Hard disk drive
Release latch
Figure 65. 3.5-inch hard disk drive removal
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Installing a 3.5-inch hard disk drive
Use this information to install a 3.5-inch SAS/SATA hard disk drive.
Before installing a 3.5-inch hard disk drive, read the following information:
• Inspect the drive tray for signs of damage.
• To maintain proper system cooling, do not operate the server for more than 10 minutes without either a
drive or a filler panel installed in each drive bay.
To install a 3.5-inch SAS/SATA hard disk drive, complete the following steps.
Step 1. Read “Safety” on page v and “Installation guidelines” on page 89.
Step 2. If the compute node is installed in an IBM NeXtScale n1200 Enclosure, remove it (see “Removing
a compute node from a chassis” on page 92 for instructions).
Step 3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node
with the bezel pointing toward you.
Step 4. Remove the cover (see “Removing the compute node cover” on page 105).
Step 5. Remove the filler panel, if one is present.
Step 6. Touch the static-protective package that contains the disk drive to any unpainted metal surface on
the server; then, remove the disk drive from the package and place it on a static-protective surface.
Step 7. Align the drive with the guide rails in the bay; then, carefully slide the drive assembly into the drive
bay until the drive snaps into place.
Chapter 5
.
Removing and replacing components
143