Figure 62. HDD/SSD removal
Step 5. Remove the SATA signal connector from the HDD/SSD drive.
HDD/SSD drive
SATA signal connector
HDD/SSD drive screws
Figure 63. SATA signal connector removal
If you are instructed to return the server component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Replacing a hard disk drive (HDD)/solid state drive (SSD)
Use this information to install a hard disk drive (HDD)/solid state drive (SSD).
Read the safety information in Safety and Installation guidelines.
If you are replacing a server component in the water-cooled technology tray, you need to remove the water-
cooled technology tray from the chassis enclosure and refer to the “Removing a water-cooled technology
tray from a chassis” on page 139 and “Installing a water-cooled technology tray in a chassis” on page 140
sections.
To install a hard disk drive (HDD)/solid state drive (SSD), complete the following steps:
Step 1. Turn off the water-cooled technology tray and peripheral devices and disconnect the power cords
and all external cables.
Step 2. Remove the cover (see “Removing the cover” on page 142).
Step 3. Plug in the SATA signal connector into the HDD/SSD drive.
Removing and replacing server components
153
Summary of Contents for NeXtScale n1200
