Lenovo LXM-L19BH
Page 28 of 44
8.2 TROUBLE SHOOTING
8.2.1 MAIN BOARD
1.NO SCREEN APPEAR
Note:1. If replace “MAIN-BOARD”, Please re-do “DDC-content” programmed & “WHITE-Balance”.
2. If replace “Power Board” only, Please re-do “ WHITE-Balance”
Led Green
Measured CN801 pin5/6 = 12V?
Measured CN801 pin 9/10= 5V?
Measured U802 pin 2= 3.3V?
Check Correspondent component.
Is there any shortage or cold solder?
Yes. There is OSD show
Yes, all DC level exist
Disconnected the Signal cable (Loose the
Signal cable), Is the screen show “Cable Not
Connected”?
Connected the Signal cable again,
Replace U401
Show noting
Connected the Signal cable
again
Check Power switch is in Power-on
status, and check if Power switch had
Led Green
Check the Wire-Harness from CN503
Measured RGB (R318, R319, R320)
H,V Input at U401 pin 181,182 ,does
Check digital signal from CN301
Check Correspondent
component short/open
(Protection Diode)
NG
Check Panel-Power Circuit Block
Check U401 Data-output Block
Inverter control relative circuit
Re-do White balance adjust
Measured Crystal X401 (14.318MHz)
OK
Summary of Contents for LXM-L19BH
Page 13: ...Lenovo LXM L19BH Page 13 of 44 h t t p w w w w j e l n e t ...
Page 16: ...Lenovo LXM L19BH Page 16 of 44 Power Block Diagram h t t p w w w w j e l n e t ...
Page 25: ...Lenovo LXM L19BH Page 25 of 44 7 PCB LAYOUT 7 1 MAIN BOARD h t t p w w w w j e l n e t ...
Page 26: ...Lenovo LXM L19BH Page 26 of 44 7 2 Power Inverter Board h t t p w w w w j e l n e t ...