Lenovo ideapad 510S, Hardware Maintenance Manual, Page: 37 / 69

Step 6. Insert a screw driver into the hole at the bottom of the device as shown, and then bend the screw
driver gently until the rear cover and the chassis are separated.
Step 7. To reattach the rear cover:
a. Align the screw holes in the rear cover with the corresponding holes in the bottom of the
computer.
b. Press the rear cover until it snaps into position.
c. Secure the rear cover to the chassis with two screws.
Removing the stand holder
Attention: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo
recommends that you use a blanket, towel, or other soft cloth to protect the touch screen from scratches
or other damage.
Step 1. Remove any media from the drives, shut down the operating system, and turn off the computer
and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to Locating connectors,
controls and components to locate the various connectors.
Step 4. Remove the stand base. Refer to Removing the stand base.
Step 5. Remove the rear cover. Refer to Removing the rear cover.
Chapter 8
.
Replacing hardware
31