Lenovo ideacentre 200, Hardware Maintenance Manual, Page: 103 / 140

Note: When the computer is turned on for the first time after replacing the
coin-cell battery, an error message might be displayed. This is normal after
replacing the coin-cell battery.
Replacing the M.2 storage drive
To replace the M.2 storage drive, do the following:
1. Remove any media from the drives and turn off all connected devices and
the computer. Then, disconnect all power cords from electrical outlets and
disconnect all cables that are connected to the computer.
2. Remove the front cover. See “Removing the front cover” on page 83.
3. Remove the system board frame. See “Replacing the system board frame”
on page 88.
4. Locate the M.2 storage drive slot. See “Locating parts on the system board”
on page 45.
5. Remove the screw that secures the M.2 storage drive to the system board so
that the M.2 storage drive pops up.
Figure 24. Removing the screw that secures the M.2 storage drive
6. Pull the M.2 storage drive to remove it from the M.2 storage card slot.
Figure 25. Removing the M.2 storage drive
Chapter 9. Installing or replacing hardware
95