Lenovo ideacentre 200, Hardware Maintenance Manual, Page: 96 / 140

6. Position a new memory module over the memory slot. Ensure that the notch
1 on the memory module aligns correctly with the slot key 2 on the system
board. Push the memory module straight down into the slot until the retaining
clips close.
Figure 16. Installing a memory module
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts
replacement” on page 107.
Replacing the system board frame
Attention:
Do not open your computer or attempt any repair before reading and
understanding the Chapter 1 “Read this first: Important safety information” on
page 1.
CAUTION:
The system fan might be very hot. Before you open the front cover, turn off
the computer and wait several minutes until the computer is cool.
To replace the system board frame, do the following:
1. Remove any media from the drives and turn off all connected devices and
the computer. Then, disconnect all power cords from electrical outlets and
disconnect all cables that are connected to the computer.
2. Remove the front cover. See “Removing the front cover” on page 83.
88
ideacentre 200 Hardware Maintenance Manual