Lenovo HR630X V2, User Manual

Page: 99 / 134

About this task
Attention:
• Read “Installation Guidelines” on page 27 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Remove the top cover. See “Remove the top cover” on page 106.
Step 2. Disconnect the cable of the RAID super capacitor module.
Step 3. Remove the riser assembly. See “Remove a riser card” on page 92.
Step 4. Remove the RAID super capacitor module from the riser.
Figure 68. Removal of the RAID super capacitor assembly from the riser
a. Rotate the latch on the riser bracket to the open position.
b. Remove the RAID super capacitor assembly from the riser.
c. Open the retention clip on the holder of the RAID super capacitor module.
d. Take the RAID super capacitor module out of the holder.
After you finish
If you are instructed to return the old RAID super capacitor module, follow all packaging instructions and use
any packaging materials that are provided.
Install the RAID super capacitor module on the riser
Use this information to install the RAID super capacitor module on the riser.
About this task
Attention:
• Read “Installation Guidelines” on page 27 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
Chapter 4
.
Hardware replacement procedures
91