Lenovo HR630X V2, User Manual

Page: 84 / 134

• Read “Installation Guidelines” on page 27 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Figure 48. Processor removal
Step 1. Use a Torx #T20 screwdriver to loosen the captive screws in the removal sequence shown on the
force frame.
Step 2. Slightly lift up the force frame and the rail frame in the direction shown. The processor in the rail
frame is spring-loaded.
Step 3. Hold the blue tab of the processor carrier and slide the processor carrier out of the rail frame.
After you finish
Install a new processor. See “Install a processor” on page 76.
Install a processor
Use this information to install a processor.
About this task
Attention:
• Read “Installation Guidelines” on page 27 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Notes:
• All processors on the system board must have the same speed, number of cores, and frequency.
• Before you install a new processor, update your system firmware to the latest level.
76
HR630X V2 User Guide