Lenovo Flex System EN2092, User Manual, Page: 31 / 56

To log in to the switch, complete the following steps:
1.
Connect one end of the specifically designed serial cable that comes with your
device into the mini-USB port and connect the other end to the management
station.
For additional information, see “Connecting the serial console cable” on page
10.
2. On the management station, open a console window and make sure that the
serial port is configured with the following settings:
v
9600 baud
v 8 data bits
v
No parity
v
1 stop bit
v
No flow control
3.
Type the user name and password. The default user name is
USERID
. The
default password is
PASSW0RD
. The password is spelled with a zero, not the
letter O.
The serial port is compatible with the standard 16550 Universal Asynchronous
Receiver/Transmitter (UART) protocol. The mini-USB serial port is enabled by
default.
Configuring the switch through the switch browser-based
interface
Note: HTTP is disabled by default. HTTPS is not disabled by default.
Before you can access and start the browser-based interface, make sure that you
have completed the following procedures:
v
Install the switch in the Flex System chassis.
v
Make sure that the switch firmware is installed on the switch.
v
Configure at least one IP interface on the switch.
v Enable frames and the JavaScript program in your Web browser.
The following hardware and software are required for the Web interface:
v
A frame-capable Web-browser program, such as Internet Explorer (version 7.0 or
later), Mozilla Firefox (version 8.0 or later), or Google Chrome (version 16.0 or
later).
v
A computer or workstation with network access to the switch
To start the browser-based interface, complete the following steps:
Chapter 2. Installing the switch
21