Lenovo BladeCenter HS22, Installation And User Manual

Page: 47 / 96

Step 4. Use a clean area of the cleaning pad to wipe the thermal grease from the microprocessor; then,
dispose of the cleaning pad after all of the thermal grease is removed.
Microprocessor
0.02 mL of thermal
grease
Step 5. Use the thermal-grease syringe to place nine uniformly spaced dots of 0.02 mL each on the top of
the microprocessor.
Note: 0.01mL is one tick mark on the syringe. If the grease is properly applied, approximately half
(0.22 mL) of the grease will remain in the syringe.
Step 6. Continue with step Step 2 on page 35.
Installing a USB Flash key
Use these instructions to install a USB Flash key in the blade server.
Note: For instruction on installing the USB Flash key in the IBM WebSphere DataPower Integration Blade
XI50B Type 4195 appliance, see the WebSphere DataPower Integration Blade XI50B pdsg Addendum
document available on the IBM Web site at http://www.ibm.com/systems/support/.
The following illustration shows the installation of the USB Flash key.
To install a USB module, complete the following steps:
Step 1. Before you begin, read “Safety” on page iii and “Installation guidelines” on page 17.
Step 2. Read the documentation that comes with the DIMMs.
Chapter 3
.
Installing options
37