Lenovo BladeCenter HS22, Installation And User Manual

Page: 41 / 96

10. Turn over the expansion-unit riser assembly and install the riser assembly into the expansion unit
system board, as shown in the following illustration.
11. Carefully reposition the expansion-unit riser assembly, aligning it with the expansion-unit
system-board-assembly rails.
12. Firmly slide the assemblies together until the tray-release button securely locks the panels.
13. Connect the auxiliary power cable (A), as shown in the following illustration.
A
B
14. Connect the cable to the expansion-unit system board. Replace the retention bracket and tighten the
screws (B), as shown in the illustration above.
If you have other devices to install or remove, do so now; otherwise, go to “Completing the installation”
on page 47.
Removing a GPU adapter from the BladeCenter GPU expansion unit
Use this information to remove a GPU adapter from the BladeCenter GPU expansion unit.
Notes:
1. This section does not apply to the IBM WebSphere DataPower Integration Blade XI50B Type 4195
appliance.
Chapter 3
.
Installing options
31