Lenovo 7Y45, Setup Manual

Page: 84 / 116

Step 3. Open the card latch. Position the new PCIe adapter over the PCIe slot; then, carefully press the
PCIe card straight down until it is securely seated in the slot. Close the card latch to secure the
PCIe adapter in place.
Figure 58. PCIe adapter installation
Step 4. Depending on the type of the PCIe adapter, you might need to connect any required cables. Refer
to “Internal cable routing” on page 30 or the documentation that comes with the PCIe adapter for
specific information.
Install a simple-swap drive
Use this information to install a simple-swap drive.
“
Read
the
installation
Guidelines” on
page 54
“
Power off
the server for
this task” on
page 86
“
ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 55
The following notes describe the type of drives that your server supports and other information that you must
consider when you install a drive.
• For a complete list of supported optional devices for the server, see:
https://static.lenovo.com/us/en/
serverproven/index.shtml
• The drive bays are numbered to indicate the installation order (starting from number “0”). Follow the
installation order when you install a drive. See “Front view” on page 15.
• The drives in a single RAID array must be the same type, same size, and same capacity.
Before installing a simple-swap drive:
1.
Watch the procedure
. A video of this procedure is available from the following links:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-Dy5N2dPXFx5Pht-FljAi6S
• Youku: https://list.youku.com/albumlist/show/id_51977169
80
ThinkSystem ST250 Setup Guide