Lenovo 7061, Hardware Installation And Replacement Manual, Page: 36 / 130

10. Align the drive cage pivot pin with the slot
1
in the upper drive cage and
slide the hard disk drive cage into the chassis.
11.
Connect the signal and power cables to the rear of the new hard disk drive.
12. Press down on the metal latch
2
, pivot the drive cage into place, and then
slide it forward until it snaps into position.
Note: There are two arrows, one on the upper drive cage and one on the hard
disk drive cage. The arrows are aligned when the hard disk drive is in
the proper position.
13. Go to Chapter 4, “Completing the parts replacement,” on page 45.
Replacing the secondary hard disk drive
Attention
Do not open your computer or attempt any repair before reading the “Important safety
information” in the Safety and Warranty Guide that was included with your computer. To
obtain a copy of the Safety and Warranty Guide , go to the Support Web site at
http://www.lenovo.com/support.
Figure 23. Installing the primary hard disk drive and bracket
28
Hardware Installation and Replacement Guide