Lenovo 6241, Installation And Service Manual

Page: 291 / 1990

Storage book
board assembly
Storage book
2. Install the adapters (see “Installing an adapter” on page 83).
3. Connect the cables to the adapters.
4. Connect the cables to the board assembly.
5. Close the adapter retention lever.
6. Align the storage book with the I/O bay on the server and slide it into the server.
7. Rotate the cam handle on the storage book all the way up and push it into the server until it locks in
place.
8. Reconnect the power cord and any cables that you removed.
9. Turn on the peripheral devices and the server.
Removing the front operator panel assembly
Use this information for instructions on how to remove the front operator panel.
To remove the front operator panel, complete the following steps.
Step 1. Before you begin, read “Safety” on page v and “Installation guidelines” on page 44 .
Step 2. Turn off the server (see “Turning off the server” on page 40) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the
device.
Step 3. Remove the storage book from the server (see “Removing the storage book” on page 273).
Step 4. Disconnect the front operator panel cables from the storage book board and from the rear air
baffle.
Note: You might need to use a small flat-blade screwdriver to get under the lip of the plug on the
cable (the thermistor end of the cable) to remove the plug from the air baffle and set it aside to
install on the new assembly.
Step 5. Slide the blue release latch on top of the front operator panel back to remove the operator panel.
Chapter 6
.
Removing and replacing components
277