Lenovo 3200 Series, Installation Manual

Page: 75 / 132

8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter Page
57
QConvergeConsole (QCC) CLI
QConvergeConsole Command Line Interface (CLI) is a management utility that centralizes management
and configuration of QLogic adapters within the entire network (LAN and SAN).
You can use the QCC CLI tool in either interactive or non-interactive mode to configure and manage 8200
and 3200 Series Adapters installed on either Linux or Windows host servers.
This section outlines the steps for setting up NIC partitions using QCC CLI in interactive mode. The
displayed commands apply to both Linux and Windows operating systems.
For procedures on installing and starting this management tool, refer to the QConvergeConsole CLI User's
Guide .
To set up NIC partitions using QCC CLI:
1. Start the QCC CLI interface and select option
6: NIC Partitioning <NPAR> Information
(Figure 34).
Figure 34: Selecting Option 6 to View NPAR Information Options