Lenovo 3200 Series, Installation Manual

Page: 73 / 132

8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter Page
55
3. Select the NIC Partitioning tab. The NIC Partitioning Configuration page displays configuration details
that apply to the selected NPAR configuration and personality options (Figure 32).
Figure 32: NIC Partitioning Configuration Page
4. Select the physical port you want to configure from the Physical Port drop-down list.
5. If you want to change its function type, select the NIC partition and select the desired protocol from the
Function Type drop-down list.
6. Click Save to save any changes. The Security Check dialog box may appear. In the Enter Password
box, type the password, and then click OK .
7. Reboot the adapter host server to apply the changes.
8. Verify that the configured ports have the most current drivers installed.
9. If necessary, update the driver for the port protocol.
Set Up Quality of Service (QoS) QConvergeConsole lets you set quality of service (QoS) for each
partition by setting minimum and maximum percentages of the physical port's bandwidth for each partition.
To set the QoS:
1. Expand a 8200 and 3200 Series Adapters node in the QConvergeConsole system tree.
2. Expand the physical Port 1 node and select the NIC port. The content pane displays two additional tabs
that are not available on NIC ports for physical Port 2.
Note: The NIC Partitioning page applies to NIC ports only for NPAR-enabled 8200 and 3200 Series
Adapters.