Lenovo 20YM0009GE-CAMPUS, Hardware Maintenance Manual

Page: 43 / 74

Remove the solid-state drive (SSD) bracket
Make sure the following FRUs (or CRUs) have been removed.
“Remove the lower case” on page 29
“Remove the memory module mylar” on page 34
“Remove the heat sink” on page 35
Step 1. Remove the right fan and one SSD.
Note: For details, see “Remove the fans” on page 36 and “Remove the solid-state drive (SSD)
module” on page 30.
Step 2. Remove two screws and then remove the SSD bracket.
Figure 19. Remove the SSD bracket
Screw specifications Number of screws
M2.0 x L3.5 1
1
Go to
https://support.lenovo.com/partslookup
to look up the Lenovo part number of the following replacement
part:
Solid-state drive (SSD) bracket
Remove the USB board module
Make sure the following FRUs (or CRUs) have been removed.
“Remove the lower case” on page 29
“Remove the solid-state drive (SSD) module” on page 30
“Remove the battery pack” on page 32
“Remove the memory module mylar” on page 34
“Remove the heat sink” on page 35
“Remove the solid-state drive (SSD) bracket” on page 37
Step 1. Remove the right fan.
Note: For details, see “Remove the fans” on page 36.
Chapter 4
.
Removing a FRU or CRU
37