Lenovo 1732, User Manual, Page: 43 / 106

Removing and reinstalling the foot stand
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
on page v.
Note: When a wall mount is used, foot stand can be removed and reinstalled for your preference.
This section provides instructions on how to remove and reinstall the foot stand.
CAUTION:
Turn off the computer and wait three to five minutes to let the computer cool before removing the
foot stand.
To remove and reinstall the foot stand, do the following:
1. Remove any media from the drives and turn off all attached devices and the computer.
2. Disconnect all power cords from electrical outlets.
3. Disconnect the power cords, Input/Output cables, and any other cables that are connected to the
computer. See “Locating connectors, controls, and indicators on the front of your computer” on page 7
and “Locating connectors on the rear of your computer” on page 9.
4. Place a soft, clean towel or cloth on the desk or the surface. Hold the sides of your computer and gently
lay it down so that the screen is against the surface and the cover is facing up.
5. Remove the rubber on the foot stand.
Figure 11. Removing the rubber on the foot stand
6. Remove the screw that secures the foot stand, and then remove it from the computer.
Chapter 5
.
Installing or replacing hardware
31