Page 4
Install Manual Damper - C1DAMP10C-2
1- Disconnect all power to unit
2- If manual damper is factory-installed, remove six
screws securing hood top to access panel. See figure
2. Retain hood top. Go to step 5.
3- Remove and retain sheet metal screws securing the
cover plate to the top rear access panel. Discard
cover plate. See figure 3.
FIGURE 8
FIELD-INSTALL MANUAL DAMPERS
DAMPER
BLADES
COVER PLATE
OPENING
4-
Field-Installed Dampers -
Install the two damper blades over the cover plate
opening. Secure using four provided screws. See
figure 8.
5-
Factory-Installed Dampers -
Remove two screws securing dampers in place for
shipping. See figure 9.
6- To adjust manual damper outdoor air amount, loosen
the slots screws and slide dampers to the desired
position. Tighten the screws to secure dampers in
place. See figure 9.
FIGURE 9
ADJUST MANUAL OUTDOOR AIR DAMPERS
LOOSEN FOUR SCREWS AND
SLIDE DAMPERS TO ADJUST
OUTDOOR AIR VOLUME
DAMPERS
IF DAMPER IS FACTORY-INSTALLED, REMOVE
TWO SCREWS, ONE ON EACH SIDE, SECUR
ING DAMPERS IN PLACE FOR SHIPPING
FIGURE 10
INSTALL HOOD
1
3
SECURING HOOD TOP
TO SIDES (SIX SCREWS
- DO NOT TIGHTEN)
SECURE SIDES
TO UNIT (SIX
SCREWS)
2
INSTALL BOTTOM
FILTER BRACKET
(FOUR SCREWS)
SECURE HOOD
TOP TO UNIT
(FIVE SCREWS)
4
5
TIGHTEN SCREWS
SECURING HOOD TOP TO
SIDES (SIX SCREWS)
CAULK SIDES TO
SEAL WATERTIGHT
CAULK SIDES TO
SEAL WATERTIGHT
