19
Sensor – Data Verification
This step may be required to verify whether added
wireless sensor is grouped and communicating
with the rooftop unit.
Sensor data will be displayed on the CORE Service
App dashboard screen.
Sensor – Network Removal and Reset
CORE Service App Sensor Removal
To remove the node (sensor) from the RTU, use
the CORE Service App and navigate to
RTU
Menu
>
Network Integration
>
Wireless Sensor
Network.
1. Select the node (sensor) to remove.
2. Select
Remove Sensor
at the bottom of the
screen.
3. The screen
Remove Senso
r will appear, se-
lect
Yes
to proceed.
4. Press and hold the beacon button for two sec-
onds to remove the node (sensor) from the
BLE mesh network.
5. Enter the
sensor name
on this screen and
select
Proceed.
IMPORTANT
It is recommended that any sensors that are
taken out of use should be removed from the
network and a hard reset performed.
Sensor Hard Reset
Use the following procedure to perform a sensor
hard reset.
1. Press and hold both the
beacon
and
reset
buttons simultaneously for 10 seconds.
2. Release only the
reset
button.
3. After two seconds release the
beacon
button.
After performing the hard reset, the wireless sensor
can be added to any other rooftop unit group or
added back to same the rooftop unit network.
