12
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION
MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
A.
When lighting the appliance, follow these instructions
exactly.
B. BEFORE OPERATING
smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•
Extinguish any open flame.
•
Open windows.
•
Do not light any appliance.
•
Do not touch any electrical switches.
•
Do not use any phone in your building.
FOR YOUR SAFETY READ BEFORE LIGHTING
•
Immediately call your gas supplier from a neighbor’s
phone.
•
If your gas supplier cannot be reached, call the fire
department.
C.
Use only your hand to turn the gas control lever. Never
use tools. If the lever will not turn by hand, do not try to
repair it, call a qualified service technician. Force or
attempted repair may result in a fire or an explosion.
D.
Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
LIGHTING INSTRUCTIONS — ELECTRONIC
1.
For complete shut-down, turn remote wall switch to "OFF"
or set the thermostat to the lowest setting, if applicable.
2.
Turn the ON/OFF switch to “OFF”, if Step 1 is not applicable.
3.
Close the main line shut-off valve.
TO TURN OFF GAS TO APPLIANCE
LIGHTING INSTRUCTIONS
1. STOP!
Read the safety information above on this page.
2.
Turn remote wall switch to "OFF" or set the thermostat to
lowest setting, if applicable.
3.
Turn the ON/OFF switch to "OFF" if Step 2 is applicable,
this ON/OFF switch should always be in the "OFF"
position.
4.
Verify main line shut-off valve is open.
5.
This appliance is equipped with an ignition device which
automatically lights the burner. Do Not try to light the
burner by hand.
6.
Wait five (5) minutes to clear out any gas. If you then
smell gas, including near the floor,
STOP!
Follow "B" in
the safety information above on this page.
7.
Turn "ON" all electrical power to appliance (remote wall
switch), or set the thermostat to the desired setting, if
applicable.
8.
Turn the ON/OFF switch on the appliance to "ON", if
Step 7 is not applicable.
9.
If the appliance will not operate, follow the instructions
"To Turn Off Gas To Appliance" and call your service
technician or gas supplier.
TO SHUT OFF
1.
Turn off all electrical power to the appliance (remote wall
switch) or set the thermostat to the lowest setting, if
applicable.
Inlet Gauge Port
Pilot Adjustment Screw
Hi-Lo Flame
Adjustment Knob
Manifold Gauge Port
HI
LO