3
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Step 9. Re-check snap switch position to ensure good surface con-
tact. Surface contact is critical to the optimal operation of the
switch.
Step 0. Plug the power cord into a grounded 120 VAC receptacle. Do not
route the power cord under the appliance or allow it to come in
contact with any surface of the appliance.
Figure 7
Step . INSTRUCTIONS FOR MODEL E260 ONLY -
a. Remove the existing draft rod knob.
b. Install the supplied draft rod extension through the bracket at-
tached to the bottom of the left side hearth plate, making sure
the end without the grooves is toward the insert body. Thread
the coupling nut on the end closest to the insert body and then
thread the coupling nut on the rod from the insert.
c. Locate the blower and blower extensions (see
Figure 8)
. Slide
the blower partially under the hearth plate. Run the blower
cord through the slot in the blower housing extension on the
appropriate side. Slide the left housing extension over the draft
rod on the left side and slide the right housing using the method
described below (the ends without the cord slots attach to the
blower housing). Now slide the blower assembly under the
hearth plate and center it.
Figure 8
Use the adhesive strip on the inside of the side trim pieces. Be sure
to position the side trim pieces exactly as desired then slide the trim
piece out just enough to remove the cover strip on the adhesive and
press the trim piece tightly against the blower and hold for 30 seconds.
Step 8. Tighten bolts. See
Figure 7
.
