Lenel DirecDoor, Installation Manual

Page: 40 / 90

Reader Interface
40
DirecDoor Installation Guide
•
Alpha Xtra Guard1® foil shield cable, non-plenum-rated
•
Belden series security and alarm cable (commercial applications shielded), plenum-rated
For readers not listed in the table below, refer to the applicable reader installation manual.
Refer to figure Wiring to Wiegand Readers, Door Contacts, and Exit Request on page 42 and figure
Wiring to F/2F Readers, Door Contacts, and Exit Request page 43.
Refer to figure Wiring Output Device to DO Interface on page 58.
Note: The DDSDC only supports one door strike DO relay, one alarm DI, and one exit DI on
Connector J2.
Refer to figure Wiring to Wiegand Readers, Door Contacts, and Exit Request on page 42.
J1/J3: Connecting T-5xx Series Reader
J1/J3 Pin Signal Name Reader Pigtail Colors
1 +12 VDC Red
2 Ground Black
3 Reader Data 0 Green
4 Reader Data 1 White
5 Door DO (Reader LED) Orange
J1/J3: Connecting the DO Outputs
J1/J3 Pin Signal Name Cable Color
6 16DO - DO (Open Collector) Blue
7 16DO - DO (Open Collector) Brown
8 16DO - DO (Open Collector) Yellow
J2/J4: Door and Exit DI Wiring
Pin Signal Name Cable Color
1 Supervised Door DI (Alarm Point) (1K/1K) Red
2 Supervised Door DI Return Green
3 Supervised Exit DI (Exit Request) (1K/1K) Orange
4 Supervised Exit DI Return White
J2/J4: Door Strike Relay Wiring
Pin Signal Name Cable Color
5 Ground Black
6 Door Strike Relay – Normally Closed (NC) Blue