Lenel DirecDoor, Installation Manual

Page: 30 / 90

DirecDoor Board
30
DirecDoor Installation Guide
J1 through J4
Connectors J1 through J4 are pluggable screw terminal blocks. For connectors J1 through J4 pinouts,
refer to table
J1/J3: Connecting T-5xx Series Reader on page 40 and table J2/J4: Door and Exit DI
Wiring on page 40.
Note:
The DDSDC does not have Connector J4.
J5
Connector J5 is a pluggable screw terminal block used to connect the DirecDoor I/O Expansion
Board (DDIO).
Notes:
The DDSDC does not have Connector J5 and does not support the DDIO.
Not evaluated by UL at this time.
J6
Connector J6 is a pluggable screw terminal block. For connector J6 pinouts, refer to table J6 - FACP
Input, Normally Closed on page 46.
J7
Not implemented: Connector J7 is a pluggable screw terminal block.
Notes:
The DDSDC does not have Connector J7.
Not evaluated by UL at this time.
J8
Connector J8 is a pluggable screw terminal block. Refer to table J8 - Power Input Port on page 23.
J5 - RS485 Expansion Port
Pin Signal Name
1 24 VDC Power Out
2 Ground
3 485T+
4 485T-
5 485R+
6 485R-
J7 - Not Used
Pin Signal Name
1 Reserved
2
3