16
Owner’s Manual
RetroFit Kit for Bennett Trim Tabs Wiring Diagram
E
le
ct
ric
R
e
tr
oF
it
Kit
for
Bennett
Tr
im
Tabs
In
st
al
la
ti
on
In
st
ruc
ti
on
s Continued
3) Now you will need to hook up the Lenco Actuator wir
es inside the bilge/rigging ar
ea.
First cut the wir
e connector fr
om the Bennett
wir
e harness wher
e the pump used to be.
Strip the four harness wir
es, cut the pins on
the four Lenco actuator wir
es, and strip these
four wir
es. Connect these wir
es as per the
diagram below
, using the heat shrink butt
splices pr
ovided in the kit. Make sur
e to use
the pr
oper crimping tool and then heat all
connections for a tight waterpr
oof seal.
Tie-wrap or secur
e in some fashion to a dr
y
location to help pr
event the connectors fr
om
getting too wet.
For further assistance please visit our website at www
.lencomarine.com
Wiring Instructions For Connecting Lenco Actuator Wir
es to Existing Bennett Rocker
Switch
1)
Disconnect all wir
es fr
om the Bennett
rocker switch. Remove and discar
d all brass
strips. Reconnect the four wir
es fr
om the
existing Bennett wir
e harness to the back of
the Bennett switch as per the diagram below
.
2)
Now find a 12 volt negative at the helm/
Connect this to the 3’ black jumper wir
e with the non-
terminated end. Attach to scr
ew terminal on the back
of the Bennett switch as per the diagram below (-12 V
olt Black). Attach the orange, black, yellow
, r
ed,
gr
een, and blue short jumper wir
es to the back of
the Bennett switch as per the diagram below
. The
12 volt positive (+) should alr
eady be at the switch
fr
om the pr
evious system. Simply r
econnect it as
per the diagram below
.
console.
3) T
est the trim tabs for pr
oper operation.
that the right switch contr
ols the left trim tab and
the left contr
ols the right. Bow down should extend
the tabs while bow up should r
etract them. If for
some r
eason this does not work as described in the
above text then r
echeck all the wiring for a misplaced
wir
e. If still not fully operational r
efer to the trim tab
tr
ouble shooting guide in the owners manual for
further instructions.
Remember
Wiring Diagram for Bennett Rocker Switch
White
Red
Blue
Gr
een
Yellow
Black
White
Black
+ 12V
Orange
- 12V
Black
Top (Bow Down)
Bottom (Bow Up)
Cut quick disconnect
at pump and connect
to Lenco actuator wir
es
Existing Bennett
wir
e harness
Port
Starboar
d
