9
Press the Enter button and the display will show “Factory Reset?”. Press the Next button until the word
“YES” is flashing.
Press the Enter button again, this will reset the radio.
Snooze Function
When the alarm sounds, press the Enter/Snooze button to delay the alarm for another 9 mins. The
radio will go to Standby mode.
You can press Power/Mode button to stop the Snooze function and go to the operation mode before
the alarms rings.
FAQs
Problem
Solution
No sound
The station is not tuned in. Fine tune the station.
The volume is set to a low position. Increase the volume.
Headphones may be connected. Disconnect the headphones.
Buttons are not working
Turn off the unit and turn on after a few seconds.
FM: Static sound
DAB: Burbling/intermittent
cut - out
Signal reception is too low. Adjust the aerial or move the unit to a
stronger signal location.
Rescan stations.
Sound is destorted
The volume is too high. Adjust the volume control.
Desired station not found
Weak signal. Use the manual tune function.
Display shows “No Service”
There is no DAB coverage in your area, or poor receiption. Adjust the
position of the aerial, or move the unit to a stronger signal location.
Display is blank
This may occur if the broadcaster changes the label of a service or
removes a label while tuned. The radio will try to retune or perform a
scan.
Specifications
Power supply
Built-in battery
Frequency rangs
FM 87.5-108MHz
DAB 174-240 MHz
Output connector
3.5mm earphone socket
Aerial
Telescopic antenna
Power supply adaptor (For EU only)
Manufacture
Shenzhen Adition Audio Science &Technology Co.Ltd
Input
AC 100-240V~50/60Hz,0.15A Max
Output
DC 5V/1A
Mode Number
AD050501000EUU
Use only original AC adaptor
Use only the power supply listed on the user
instructions
Play Time
Your radio has a play time of around 3-5 hours. This is dependant on signal strength and volume
selection of the radio
