The following guides you step by step through the initial set up of the navigation system.
Firstly, remove the foil for protecting the device during transportation from the display,
if any.
Switching on the navigation system
The Navigation System will start the initial installation automatically. The brand logo
will appear and your device will display the application screen after a few seconds.
You set the date and the time by means of the
Setting Button
on the touch screen
and the date/time control button. Set the applicable time zone, if available.
Attention:
According to the charging status of the accumulator installed. It is necessary
for the device to be charged before the initial setting up can run through.
Charging Battery of the Navigation system
Note:
While charging, the Battery Charge Indicator is red.
You have different possibilities to charge the battery of your navigation system:
• With the help of the network adapter.
• By means of the car adapter.
• The battery charge indicator lights red until the navigation system is fully charged.
Do not interrupt the charging before the battery is fully charged. It will take a few
hours for the navigation system to be fully charged. When the battery is fully charged
the battery indicator will turn to green.
•
Note:
You can use the navigation system during the charging process, but the power
supply must not be interrupted during initial set-up.
• Leave the main adapter connected to the navigation system for around 24 hours,
so that the backup battery can be fully charged.
• You can leave the main adapter connected, and this is very handy for continuous
operation. However, the main adapter also requires power even when it is not charging
up the battery of the navigation system.
2
1
Push the adapter connector into the guide on the right of the network adapter. Push
the Network Adapter (2) into a power point that is easily accessible.
Push the cable of the Network Adapter (1) into the network adapter connection of the
navigation system.
Working with memory cards
Your navigation system supports SD memory cards.
Inserting memory cards
1.Carefully take the memory card out of its packing (if included). Do not touch or dirty
the contacts.
2.Push the memory card carefully into the card bay. The side of the memory card
wearing the label must point upwards. The memory card should slightly lock in place.
Removing memory cards
• Do not remove the memory card while it is accessed. This could result in loss of
data.
1.To remove the card press lightly onto the upper edge until it ejects.
2.Pull the card out without touching the contacts.
3.Store the memory card in the packing or in another safe location.
• Memory cards are very fragile. Take care not to dirty the contacts and not to force
6
INSTALLATION
NAV-600 Operation manual
Summary of Contents for NAV-600
Page 1: ...NAV 600 OPERATION MANUAL ...