LENCO MC-140, Instruction Manual

Page: 6 / 10

5
1. Set the unit to TUNER mode.
2. Press BAND button to select band (AM or FM), and tune into a station.
3. Press the MEMORY button. "MEMORY" shows on the display. Then press MEMORY UP button or
Memory DOWN button to select the first storing location.
4. Press the MEMORY button again to store.
5. Search another station, repeat steps 3 & 4 until all desired stations are stored. Up to 40 stations can be
programmed (10 for AM and 30 for FM).
6. Press MEMORY-UP or MEMORY-DOWN button to listen to the stored station directly.
USING THE CD/MP3
Discs for Playback
This system can playback all digital audio CD/MP3, finalized digital audio CD-Recordable (CD-R) discs,
finalized digital audio CD-Rewritable (CD-RW) discs and CD-DA format digital audio CD/CDR/
CD-RW discs.
LOADING A DISC
1. Press the FUNCTION switch to select CD playing mode.
2. Open the CD door, OPEN will be shown on the display.
3. Place an audio CD/MP3 disc into the tray with the label side facing up.
4. Close the CD door. The display will show CD READ , then the total number of tracks, album (if a
MP3 disc contains several albums) and STOP will appear on the display after several seconds.
5. To remove the CD, press OPEN to open the CD compartment lid, the display will show OPEN .
Take the CD by its edges and carefully lift it out the device.
Note:
Make sure the disc is stopped before open the CD compartment.
To ensure a
good system performance; you need to wait until the disc tray completely reads the disc
before proceeding.
If no disc loaded into the compartment, or the disc is unreadable, the display will show
NO DISC .
PLAYING A DISC
1. Press PLAY/PAUSE button to start the playback. The playback starts at track 1. To interrupt the
playback, press the PLAY/PAUSE button again. The elapsed time will flash on and off in the display.
Example:
00:57 flashes on and off.
To resume playback, press PLAY/PAUSE button again.
2. To stop the playback, press the STOP button. The total number of tracks and playing time (only
Audio CDs) will appear in the display (MP3 shows number or folders and tracks).
SELECTING A DESIRED TRACK/PASSAGE
To select a desired track
CD: Press CD SKIP BACK/FORWARD & RADIO TUNING UP/DOWN button repeatedly in stop
mode or during playing until the desired track appears on the display.
MP3: Press the MEMORY UP / ALBUM + button repeatedly in stop mode or during playing to select
desired album. Then press CD SKIP BACK/FORWARD & RADIO TUNING UP/DOWN button to
select desired track.
Press PLAY/PAUSE button to start play.
To search for a particular passage during playback (track scanning at high speed)
Press and hold CD SKIP BACK/FORWARD & RADIO TUNING UP/DOWN button to scan the current
playing track at high speed until desired point (passage), then release the button for normal playback
mode. Playback will start again from this point.